Also included were four additional AIEC strains that came from patients with extraintestinal infection (two with sepsis and two with urinary tract infection [49, 50]). AIEC reference strain LF82 and the isogenic mutant LF82-ΔfliC were used as controls. Relevant characteristics of the strains that were known prior to this study are compiled in Table 1. All procedures were approved by the ethics committee of clinical investigation of the Hospital Josep Trueta of Girona in compliance with the Helsinki declaration. Biofilm formation assay Biofilm formation assays were performed Selleck STA-9090 using a previously described method [26] with some modifications [25]. Strains were grown overnight in Luria-Bertani broth

with 5 g l-1 of glucose (Sigma-Aldrich, St. Louis, USA) at 35.5°C, then 1/100 dilutions were made in M63 minimal medium (US Biological, Swampscott, USA) supplemented with 8 g l-1 (0.8%) glucose. Then, 130-μl aliquots were placed in wells of non-cell-treated polystyrene microtiter plates (Greiner Bio-one, Stuttgart, Germany) and incubated overnight at 30°C without shaking. Afterwards, growth optical densities

(OD) were read at 630 nm; then the wells were washed once, adhered bacteria were stained with 1% crystal violet solubilised in ethanol, and ODs read at 570 nm. Biofilm Belinostat measurements were calculated using the formula SBF = (AB-CW)/G, in which SBF is the specific biofilm formation, AB is the OD570 nm of the attached and stained Ribose-5-phosphate isomerase bacteria, CW is the OD570 nm of the stained control wells containing only bacteria-free medium (to eliminate unspecific or abiotic OD values), and G is the OD630 nm of cell growth in broth [51, 52]. For each assay, 16 wells per strain were analyzed,

and the assays were performed in triplicate, which resulted in a total of 48 wells per each tested strain and control. The degree of biofilm production was classified in three categories: weak (SBF ≤ 0.5), moderate (0.5 > SBF ≤ 1), and strong (SBF > 1). Adhesion and selleck products invasion assays in epithelial cells Intestine-407 The epithelial cell line Intestine-407 was used for adhesion and invasion assays (ATCC accession number CCL-6™). Cell culture was performed as described previously [48]. To quantify adhesion and invasion properties, a gentamicin protection assay were performed as previously described [48]. Briefly, 24-well plates containing 4×105 cells/well incubated for 20 hours were infected at a multiplicity of infection of 10. Duplicated plates, for adhesion and invasion assays were incubated for 3 hours at 37°C. For bacterial adhesion assays, cell monolayers were washed 5 times with PBS and lysed with 1% Triton X-100. Adhered bacteria were quantified by plating them in nutrient agar. Plating was performed in a maximum period of 30 minutes to avoid bacterial lysis by Triton X-100. Adherence ability (I_ADH) was determined as the mean number of bacteria per cell.