Figure 3 Absorption spectra of the CNNC arrays grown at different CH 4 /N 2 feeding gas

ratios. The CH4/N2 feeding gas ratios were 1/80, 1/40, 1/20, 1/10, and 1/5, respectively. For the CNNC arrays used as the electrodes of photovoltaic devices and photodetectors, their electrical properties become very important. Longitudinal resistances of the prepared CNNC arrays were measured by a platinum-cylindrical-tip contacting method. In the method, the top surface of the platinum cylindrical tip with a diameter of 1 mm directly contacted the CNNC arrays. The electrical testing diagram of the CNNC arrays is shown in Figure 4a, and the TEM micrograph of a CNNC pressed by the platinum cylindrical tip is shown in Figure 4b. The current-voltage (I-V) curves for the samples prepared at different CH4/N2 SBI-0206965 ratios of 1/80 to 1/5 are shown in Figure 4c. All I-V curves are nearly consistent with linear characteristics, and the resistance values in a circular area with a diameter of 1 mm can be obtained by fitting the corresponding slanted lines. According to the distribution density and average size of the CNNCs (estimated through the FESEM and TEM images of the as-prepared samples), the resistivities ρ of the as-grown CNNCs at different CH4/N2 ratios can be calculated by the following equation: where R is the resistance value in a circular area with a diameter of

1 mm, n is the number of CNNCs in the area contacted by the platinum cylindrical tip, h 2 is the average height of the nanocones, h 1 is the average loss height caused by the contact with the Belnacasan platinum cylindrical tip, and θ is the cone

angle. According to the measured resistance (Figure 4c), the resistivity of the as-grown CNNCs can be calculated, and the results are shown in Figure 4d. In the above calculations, the impacts of the Luminespib price Ni-containing substances Carteolol HCl in the central pipes on the resistance are not considered. Actually, the middle sections of most central pipes (if not all) are empty due to thermal expansion and contraction, and sometimes the central pipes at the tips are also empty by TEM observations (we have not observed the whole central pipes filled by the black substances), i.e., the Ni-containing substances in the central pipes are disconnected. Besides, the resistivity of the Ni-containing substances in the central pipes is uncertain for the atomic percentages of Ni in them are only 30% to 40% or more, and a large part of the ingredients of the Ni-containing substances are CN x . If there exist central pipes filled with continuous Ni-containing substances and the resistivity of the Ni-containing substances is less than the CN x bodies, the resistance of the CNNCs may be reduced; if not, the influence of the central pipes on the resistance of the CNNCs will be little.