Cultivation performance was in general judged by the yield of the CX production. As units, the yield per volume of cultivation broth (g 1000 m L-1) and specific yield per biomass cell weight g 1000 m L-1 were measured at the end of cultivation. For determination of specific productivity the growth curve of the D. natronolimnaea

svgcc1.2736 strains, using Dorsomorphin datasheet BDW, as biomass was integrated, yielding the biomass dry weight integral (BDWI). (6) For biomass dry weight was determined following the protocol given by Wucherpfennig (2011) with medications. buy 3-MA Culture samples (10 mL) were taken in 20-mL centrifuge tubes. The cells were measured gravimetrically by filtering (Nalgene 300–4100) a defined amount of biomass suspension through a predried and pre-weighted suction filter (Filter Paper, Grade 392, Anugrah Niaga Avapritinib clinical trial Mandiri) and dried at 105°C to a constant weig for 48 h. Prior to drying (105°C at 48 h), the filter was rinsed several times with deionized water to remove medium components from the biomass [77]. The biomass dry weight concentration (g 1000 m L-1) was calculated as the difference between the weight of the filter with and without dried biomass divided by the sample volume. CX extraction and analysis Extraction of the CX was done following the method

described previously by Asker (1999) with modifications; 10 mL aliquots

of cultures were centrifuged at 7,000 g (3–6°C) for 20 min using a cooling centrifuge (Eppendorf, 5427 R). The cell pellets were washed twice with deionized water (NaCl; 9 g L-1) and centrifuged again. These cells were resuspended three times in 6 ml of methanol by repeated Ketotifen centrifugation for 18 min until the cell debris turned colorless and transferred to hexane (HPLC Waters Acquity 2996 PDA) [78]. The CX extracts were subsequently filtered through a 0.45 μm hydrophobic PTFE membrane (Waters) and analyzed by scanning the absorbance in the wavelength region of 350–650 nm using the UV–Vis spectrophotometer (U-2800, Hitachi). The maximum absorbance was determined at a wavelength of 474 nm=λ max. The results are given as CX yield (mg)/1,000 mL of culture. Chromatographic separation was performed on a reverse-phase C18 column (250 mm×4.6 mm, Waters) where the temperature of the column was maintained at room temperature. The mobile phase used was a mixture of methanol and acetonitrile (20:80, V/V) at a flow rate of 1 mL min-1. The pressure was 1.05 kpsi and the injection volume was 20 μL. The peaks were evaluated based on their absorbance at 474 nm. Retention time and concentration of the samples were compared with pure standards of CX (Sigma-Aldrich, USA). CX amount was calculated by using the formula recommended by Schiedt (1995) [79].